Select needle cartridge
For the BB Shine Treatment you use a Nano Needle Cartridge and a penetration depth of 0.25mm. The speed is 6.

Cleaning the face
Wash your hands thoroughly with soap. Shake the bottle of BB Shine – Step 1 Cleansing Gel well to spread the microsilver. Put a generous amount of cleansing gel in one hand, spread the gel between your hands, and then apply it evenly to your face using circular motions. Now take a compress, a clean small towel or a clean cleaning sponge. Soak it with warm water and remove the cleansing gel.

If there are still residues such as make-up or dirt particles on the skin, repeat the process.

Fight & prevent acne
Take a pump of the BB Shine – Step 2 Enzyme Peeling and spread it evenly over your face in a circular motion. Spare the lips and eye area. The Enzyme Peeling should be left on for 15 minutes. In case you have a steamer,you can use this to enhance the effect of the enzyme peeling.Now take again a compress, a clean small towel or a clean cleaning sponge. Remove the Enzyme Peeling with the cloth.

Skin Primer
Soak two cotton pads generously with the BB Shine – Step 3 Skin Primer and sweep over the face in parallel motions. Spare the mouth and eye area. The Skin Primer does not need to be removed and dries on the skin.

Hyaluronic acid serum
Drip 2-3 drops of the BB Shine Hyaluronic Acid Serum on the first part.

Important: Do not immediately spray the entire treatment area; this is counterproductive, especially for larger areas. Otherwise, the serum will be absorbed elsewhere, even though you have not yet finished needling the first area.

Dermapen
Now go over the Dermapen with the nano needle cartridge and 0.25mm penetration depth over the first area. While doing this, make small, circular and brisk movements. Do not apply any additional pressure. Go over the same spot a total of 5x.

So the order is always as follows:
1. drizzle skin area with serum.
2. needle skin area.
3. drizzle the next area with serum.
4. needle the new area.

Important: Do not simply continue needling to the next area of skin, but set the Dermapen down between each zone and then reposition it.

Apply pigment
Now, directly from the pump bottle, apply pea-sized dabs of pigment of the BB Shine Pigments onto the first treatment area. There should be about 5mm space between each dab.

Important: Do not immediately dab the entire face. Otherwise the pigment will be absorbed elsewhere, even though you have not yet finished needling the first area.

Dermapen
Now, as before with the hyaluronic acid serum, go over your skin with the Dermapen over your skin. Do not remove excess pigment from the skin, it should remain there.

Apply Madecassoside sheet mask
Take the Madecassoside mask from the package and place it on your face starting from the nose. Now press the mask against your skin from the center of your face outwards. You can apply the remaining ingredients that are left in the package to your neck and décolleté. Leave the mask on for 15 minutes. If the mask active ingredient is not completely absorbed, you can work it in with light pressure movements.

Optional: Put on LED mask
Set the BB Shine Premium LED Mask to the desired light color and put the LED mask on the sheet mask. Leave this to work for 15 minutes together with the sheet mask. Take them off afterwards.

Ectoin & Aloe Vera Gel
If there is still excess pigment on the skin, swab it off with a paper towel. Then apply a pump of the BB Shine – Step 7 Ectoin & Aloe Vera Gels on one hand, spread the gel between the fingers of both hands and gently press it into the skin.

Apply Hyaluronic Routine Cream
Put a pump of the BB Shine – Step 8 Hyaluronic Routine Cream on one hand, spread the cream between the fingers of both hands and gently press it into the skin.