Select needle head
Select the appropriate needle head for your desired treatment. You can find out which needle head is the right one in our

Needle head overview

.

Cleaning the face
Wash your hands thoroughly with soap. At the beginning of a microneedling treatment, it is important to remove all residues such as fat, dust, dirt and make-up from the area to be treated. Put a generous amount of the BB Shine – Step 1 Cleansing Gel or a comparable cleansing gel into one hand, distribute the gel between your two palms and then apply it evenly to the face with circular movements. Now take a compress, a clean small towel or a clean cleaning sponge. Soak the cloth with warm water and remove the cleansing gel.

If there are still residues such as make-up or dirt particles on the skin, repeat this process.

Fight & prevent acne
Take a pump of the BB Shine – Step 2 Enzyme Peeling and spread it evenly over your face in a circular motion. Spare the lips and eye area. The Enzyme Peeling should be left on for 15 minutes. In case you have a steamer,you can use this to enhance the effect of the enzyme peeling.Now take again a compress, a clean small towel or a clean cleaning sponge. Remove the Enzyme Peeling with the cloth.

Skin Primer
Soak two cotton pads generously with the BB Shine – Step 3 Skin Primer and sweep over the face in parallel motions. Spare the mouth and eye area. The Skin Primer does not need to be removed and dries on the skin.

Serum
Drizzle 2-3 drops of the active ingredient on the first batch.

Important: Do not immediately spray the entire treatment area; this is counterproductive, especially for larger areas. Otherwise, the serum will be absorbed elsewhere, even though you have not yet finished needling the first area.

Dermapen
Now go with the Dermapen in the appropriate speed level and penetration depth over the first lot. While doing this, make small, circular and brisk movements. Do not apply any additional pressure. Go over the same spot a total of 5x.

So the order is always as follows:
1. drizzle skin area with serum.
2. needle skin area.
3. drizzle the next area with serum.
4. needle the new area.

Important: Do not simply continue needling to the next area of skin, but set the Dermapen down between each zone and then reposition it.

Apply Madecassoside cloth mask
Take the

Madecassoside mask

from the package and place it on your face starting from the nose. Now press the mask against your skin from the center of your face outwards. You can apply the remnants of the mask active ingredient that are in the outer packaging to your neck and décolleté. Leave the mask on for 15 minutes. If the mask active ingredient is not completely absorbed, you can work it in with light pressure movements.

Optional: Put on LED mask
Set the

BB Shine Premium LED Mask

to the desired light color and put the LED mask on the cloth mask. Leave this to work for 15 minutes together with the cloth mask. Take them off afterwards.

Ectoin & Aloe Vera Gel
Put a pump of the BB Shine – Step 7 Ectoin & Aloe Vera Gels on one hand, spread the gel between the fingers of both hands and gently press it into the skin.

Incorporate Hyaluronic Routine Cream
Put a dollop of the

BB Shine – Step 8 Hyaluronic Routine Cream

on one hand, spread the cream between the fingers of both hands and gently press it into the skin.